Antenna Mount Support Struts

BMW 2.5 mm high current plug to connect radios and other devices to the radio power plug on your BMW motor. BMW plug Code A (black housing) supplied with two sockets for 14 - 18 AWG wire connections (w/conductor & insulation crimps). Formerly BMW PN 71 60 2 452 887

FMS Accessories offers the bushing and bolt kit needed to mount various accessories to the handlebars on the K52 / 2015 - 2022 R 1200 / 1250 RT-P including radar remote controllers, microphone mounts, cell phone holders, etc. The kit includes a special aluminum bushing, stainless steel washer and pan-head stainless steel Torx head bolt. The kit is available in standard length as well as +5 mm and +10 mm longer bolts for use when multiple brackets are attached to one side. The M10 Torx head bolt already has encapsulated thread locker on the bolt end - the Torx head enables you to apply the required 40 Nm of torque as specified by BMW without deformation. Formerly BMW PN 71 60 2 452 841

Rear side emergency light mounting brackets are available for the Feniex Fusion auxiliary emergency lights sold by FMS Accessories. These plates are cut and formed stainless steel along with the appropriate stainless steel mounting screws, washers, rivets and Nylock nuts. The lights can be positioned either side facing or rear facing if desired. Feniex Fusion lights purchased separately. Note: Mounts contain a LH and RH bracket (pair) with hardware.

Many agencies wish to add more rear lighting when laptops are used and the radio box lid (with half of your lighting) is opened facing the sky. Adding additional emergency lighting to 2015 - 2024 R 1200/1250 RT-P models has been a challenge as the flasher board system capacity is limited to the full complement of lighting available from BMW and does not respond well to additional loads. The Emergency Light Multiplier (ELM) enables you to add up to 12 additional LED emergency lights! The harness for lights #1 & #2 are included in the ELM wiring harness. Not compatible with 2026 R 1300 RT-P models. After selecting the ELM module, move to lighting to select the lights you wish the ELM to control such as the NEW Feniex Fusion LED lights.