Replacement halogen map light bulb for older non-LED BMW / Littlite map lights. Fits map lights with a dual-prong bulb socket. Two o'rings are included with each bulb, but may not be necessary depending upon age / condition of map light. Free shipping is limited to the continental United States. Shipping charges apply to international shipments.
Replacement Part: The Santa Cruz SC-1 gun lock is one of the most popular locks on the market today and used on all of the weapons mounts sold by FMS Accessories. The SC-1 now features the round barrel key lock along with reinforced electric lock release and is standard on all weapon mounts sold by FMS Accessories. Note that a longer 25" cable is required for 2019+ F-Series models).
Replacement muzzle cup for the BMW M4 Combat assault rifle mount. Utilizes stainless steel hardware to reduce corrosion. Offered in standard or suppressor size - pick from drop-down list. Rifle mounts do not change the factory recommended load limits of the motorcycle.
Now In Stock! FMS has created a rifle cover that is easily removed for fast access to your rifle. Agencies have requested a cover designed to make exterior mounted rifles look less threatening to the general public and provides some dust and water protection at the same time. The cover, made of rugged 1,000 denier ballistic nylon, is attached with two Velcro straps. The handy loop at the top makes removal quick by detaching the two Velcro straps and lifting the cover off the rifle. The cover was designed to fit rifles with carry handles / smaller optics. Note that the cover only extends down to cover the forearm to avoid issues related to exhaust heat.
FMS has created a rifle heat shield to deflect the exhaust heat when your rifle mount is adjusted where the muzzle cup is directly in line with the exhaust from the muffler. Examples have been reported where the plastic dip coating on the muzzle cup melts-off. This new heat shield should prevent that. Most typically needed for RH long rifle mounts where the muzzle tip is directly in-line with the exhaust outlet.
Replacement pin for AR15 models with Torx security screw to prevent unitended removal of the pin while in a rifle mount. Rifle mounts do not change the factory recommended load limits of the motorcycle.
Replacement rubber retaining strap for the Classic BMW Shotgun Mount (older version) that uses a BMW battery retainer strap. Shotgun mounts do not change the factory recommended load limits of the motorcycle.
Replacement 45" Velcro strip attached to saddlebag inner lid storage. Includes alcohol wipe. Clean the surface thoroughly with an alcohol wipe and wipe dry with a clean cloth prior to installation. Allow the Velcro adhesive to "cure" for 24 hours prior to using the Inner Cover. Accessories do not change the factory recommended load limits of the motorcycle. Free shipping is limited to the continental United States. Shipping charges apply to international shipments.
Replacement Part: 20" Power Cable for FMS Accessories BT Amplifier. Depending upon which power source is available, power can be provided from either radio power supply plug, radar power plug, ACC 1-3 plugs on BMW plug strip or from lighter socket plug (when lighter socket / plug strip is removed). Note: If multiple devices are being powered by the radio circuit, you can use the FMS Power Plug Divider Code A harness to divide the circuit utilizing BMW connectors. Fits 2015 and later BMW R 1200/1250 RT-P models.
Replacement Part: Wire nuts for speaker wire connection with BT Amplifier. One each red & black trimmed nut provided. Free shipping is limited to the continental United States. Shipping charges apply to international shipments.
On rare occasions, riders used to pressing very hard on the buttons can dislodge / lose the Siren / Emergency Light button cover on the RH authority handlebar switch. Fortunately, those covers are now available as a replacement part.
The lower authority switch on each side of the motorcycle is fitted with a special switch cover during the up-fitting of CHP equipment by the selling dealer. In the event of switch failure, the switch covers should be exchanged with the replacement switch. If the switch covers are damaged / broken, replacements can be ordered.